Detaprofi Medex

The special spotting agents in the Detaprofi series can be used as pre- and post-spotting agents in the solvents perchloroethylene and water. With hydrocarbon solvents (KWL), SENSENE or other solvents in accordance with the 31st BImSchV, the Detaprofi series spotting agents may only be used as a post-spotting agent. These solvents must be used as pre-spotting agents due to insufficient rinsing behavior or the risk of lowering the flash point according to post-spotting working methods. Before using these spotting agents on delicate garments and textiles with low color fastness, we recommend carrying out a hem test.Pre-spotting In the pre-spotting stage with PER, the Detaprofi series spotting agents should be rinsed out with water and the wet area covered with brushing agent. In the case of delicate textiles (e.g. wool), the wet area must be blown dry. If textiles that have been pre-treated with Detaprofi stain remover are wet-cleaned or washed, it is not necessary to rinse the treated stain areas. Treated parts should be cleaned after 20 minutes at the latest. If Detasolv is used for pre-spotting, the post-spotting methods must be followed (dry the spotting area thoroughly). Do not inhale aerosols, ensure effective suction.

Post-spotting
In post-spotting, the Detaprofis is left to work on the stain area and the effect is supported by mechanical means (spatula, brush) and steam. The treatment area is then rinsed with water using suction and blown dry with air. All detergents in the Detaprofi range can be rinsed out without rinsing.

NoteSpecialty roofing compounds should be used sparingly. The new dosing tip on the working bottle therefore allows the products to be applied drop by drop. Before applying another product, the previous one must be rinsed out well with water and blown dry as far as possible with air. In the case of stains that swell well in water, the effect of the special stain remover is significantly improved by misting the stain area with water.